Contact Now   Online Order
 
HOME
ABOUT US BALL MILL PRODUCTS NEWS SERVICE GALLERY CONTACT

  MILL SERIES
Ball Mill
Superfine Ball Mill
Raymond Mill
YGMX Series High Pressure Ultrafine Grinder
HGM Series Micropowder Grinder
High Pressure Medium Speed Grinder
High Pressure Micro-powder Grinder
Straight Centrifugal Grinder
  Production Line
Stone Crushing & Screening Plants
Sand Making & Washing Plants
Grading production line of MQX series super fine ball mill
  Beneficiation Equipment
Drying Machine
Condensing Machine
Spiral Separator
Magnetic Separator
Flotation Machine
PHOTOS
GALLERY VIPEAK


Ball mill is crucial equipment for grinding after materials are crushed. It is an efficient tool for grinding various materials into powder.
Ball mill widely applied in cement industry, chemical industry, new building materials, fire-resistant materials, fertilizer, porcelain and glass industry etc.It has two ways of grinding: dry process and wet process.

    NEWS & INFO

The main factor affecting the grinding force of ball mill is the 1112014123216ber of balls. The best 1112014123216ber of balls is connected with cylinder speed, models and materials. The 1112014123216ber of steel ball is also closely connected with the nature of the loading capacity within the cylinder. If you want to control the loading capacity of ball mill, you must make the best 1112014123216ber of balls to maintain stability and to ensure the maximum force of the grinding, so that the power consumption is least.
 
The speed of the ball mill not only affects the movement condition of the steel ball as well as the material, also influence the grinding process of the material. When the cylinder rotational speed is low, the steel ball and materials will be rising as the rotation of cylinder. If the balls and the material arrived at the dip angle is bigger than the natural dip angle, the ball will roll down along the slope.
 
At this moment the movement of the balls for grinding material force is small, and the milled powder is difficult to separate from the balls. In this case, the capacity of abrasive is small. Therefore, in general, the charging amount of the cylinder increased, the discharge capacity should also be increased accordingly. But when the loading capacity increases to a certain extent, the ventilation rate should be reduced in order to maintain a negative pressure to run. When the ventilation quantity is reduced, input quantity is greater than the output quantity, the material will be kept more and more, the output capacity of ball mill will not increase. Therefore, in order to improve the ball mill output capacity and reduce the power consumption, you should maintain the best material volume inside the cylinder.
 
Copyright © 2009 by Vipeak Heavy Industry Machinery Co., Ltd. All rights reserved
 Tel(Shanghai): 0086-21-51382188 E-mail: vipeak@vipeakgroup.com             Tel(Zhengzhou): 0086-371-67771000 E-mail: info@vipeak.com